Contact
Here you will find software-specific error messages and how to correct them. Please use the relevant installation manual to correct hardware-specific installation problems.
Please refer to the section "Overview of system messages" in online Help for a listing of additional system messages.
Error message: "The procedure entry point _resetstkoflw could not be located in the dynamic link library Msvcrt.dll."
The error message appears during start of CANoe/CANalyzer after following action:
1. Installation of a third party tool
2. Installation of the Microsoft patch "MS WindowsXP Patch KB 926436"
Further Hints:
- The error message only appears for CANoe/CANalyzer version 3.0 to 5.0
- Additional information: Miscrosoft support page: http://support.microsoft.com/kb/324762/en
Workaround for 1) and 2):
Rename the Msvcrt.dll to Msvcrt_org.dll. in the Exec32 directory of the CANoe/CANalyzer installation.
Nr 0: Unable to find PC card. Error number 0. Timeout during card initialization:
Background: No response was received when accessing the CAN hardware. This can happen if your CANalyzer installation is incompatible with the CAN hardware. You can verify this if you open the Help/About dialog. There you will find the software version, e.g. CANalyzer PRO and the hardware this installation expects. These are:
| CANcardXTD | for CANcard (NEC) |
| CANcardSJA | for CANcard SJA |
| CANAC2 | for CAN-AC2/82C200 |
| CANAC2X | for CAN-AC2/82527 |
| CAN-AC2-PCI | for CAN-AC2-PCI |
| CANcardX | for CANcardX |
| CANcardXL | for CANcardXL |
| CANcaseXL | for CANcaseXL |
| CANboardXL | for CANboardXL |
| CANcard2 | for CANcard2/EDICcard2 |
| Memorator | for Memorator/USBcanII |
| LAPcan | for LAPcan |
| DEMO | Demo driver with virtual connection CAN1-CAN2 |
CANalyzer not allowed with HW version (Software protection with CAN board):
Your CAN hardware is not enabled for CANalyzer or it was not possible to determine the enable. You should use enabled hardware.