Vector CANtech offers training at our VectorAcademy center in the Novi, Michigan office. These classes cover CAN, LIN, FlexRay and J1939 technology, distributed embedded system engineering and the operation and application of Vector tools.
Most VectorAcademy training classes can also be held at your location. Please contact Vector CANtech's training coordinator to discuss your requirements.
Which class is right for you?
| CAN Protocol: |
Recommended classes: |
| An overview of the CAN bus systems used by North American OEMs. |
- CAN Communications
- J1939 Protocol
|
| An OEM-specific CAN bus system overview. |
- Ford NOS Strategy
- DC Networking Strategy
The following classes are offered by General Motors University and are prerequisites of the Vector GMLAN Embedded Software class:
- CTIS 29236 – Overview
- CTIS 29237 – Hardware/Physical layer
- CTIS 29235 – Fundamentals
- CTIS 29233 – Application
- CTIS 29234 – Diagnostics
|
| Vector tools: |
Recommended classes: |
| To learn how to use Vector CANalyzer. |
- Introduction to CANalyzer
- Introduction to CANalyzer.J1939
|
| To learn how to use Vector CANoe. |
- Introduction to CANoe
- Introduction to CANoe.J1939
|
| To learn how to use Vector CANape and the CAN Calibration Protocol (CCP). |
- Fundamentals of CANape and Measurement and Calibration Protocols
|
| To learn how to use Vector CANdelaStudio for ECU Diagnostic Development. |
|
| Embedded Software: |
Recommended classes: |
| To learn how to implement OEM-specifc vehicle network software in a module. |
- Ford NOS Embedded Software
- Chrysler Embedded Software
- GMLAN Embedded Software
|
| Diagnostics: |
Recommended classes: |
| OEM-specific overview of module diagnostics on a CAN bus-equipped vehicle. |
- Ford Diagnostics
- CANdela / Diagnostics
|
Contact
