Class Descriptions

Vector CANtech offers training classes at our Novi, Michigan office. These classes cover CAN technology, distributed embedded system engineering and the operation and application of Vector tools.

Most VectorAcademy training classes can be held at your location. Please contact Vector CANtech's training department to discuss your requirements.

CAN Protocol:	Recommended classes:
An overview of the CAN bus systems used by North American OEMs.	CAN Communications J1939 Protocol ISO11783 Protocol
An OEM-specific CAN bus system overview.	Ford NOS Strategy DC Networking Strategy The following classes are offered by General Motors University and are prerequisites of the Vector GMLAN Embedded Software class: CTIS 29236 – Overview CTIS 29237 – Hardware/Physical layer CTIS 29235 – Fundamentals CTIS 29233 – Application CTIS 29234 – Diagnostics
Vector tools:	Recommended classes:
To learn how to use Vector CANalyzer.	Introduction to CANalyzer Introduction to CANalyzer.J1939
To learn how to use Vector CANoe.	Introduction to CANoe Introduction to CANoe.J1939 Introduction to CANoe.ISO11783
To learn how to use Vector CANape and the CAN Calibration Protocol (CCP).	Fundamentals of CANape and Measurement and Calibration Protocols
Embedded Software:	Recommended classes:
To learn how to implement OEM-specifc vehicle network software in a module.	Ford NOS Embedded Software DaimlerChrysler Embedded Software GMLAN Embedded Software
Diagnostics:	Recommended classes:
OEM-specific overview of module diagnostics on a CAN bus-equipped vehicle.	Ford Diagnostics